[nickb45502]

Agreed, already added to my list of things to do.

 

[nickb45502]

I do have a question though, was this Plug and Play or did you need a ECU Flash? From what you've all said, its Plug and Play, I'm just trying to figure this out before i take the plunge.

 

[nickb45502]

Went to my dealer to get parts, they were clueless as to if it was possible, so I showed them this article. They are willing to use my vehicle as the test subject to see if it is but for 2 hours worth of labor. So should I have them do it? And is there anybody in southwest or northeast Ohio that could do it for me? I've never had to pull a wheel off and I don't want to screw anything up.

 

[nickb45502]

Is there anyone near the Springfield Ohio area who could put this in a '14 for me? I'm not confident enough is pulling the wheel off myself but I have the parts already.

 

[nickb45502]

No, I haven't bitten the bullet yet, I got the parts and a rough estimate from my dealer. I still want to do this DIY though, I'm just not confident enough to pull the wheel off

 

[nickb45502]

Finally did this today! Once I figured out the pin thing holding the horn/airbag the rest was not bad. Used an air impact to remove the nut on the wheel then popped it off.
Cruise baby!!!